How to install Magpul Enhanced Trigger Guard?

There are a few different ways to install the Magpul Enhanced Trigger Guard (ETG). Below is one method that should work for most people.

First, remove the old trigger guard from your lower receiver. Some people find it helpful to use a rubber mallet to do this, while others use a punch and a hammer.

Next, insert the new ETG into the lower receiver. You may need to wiggle it around a bit to get it in place.

Finally, use a screwdriver or other tool to tighten the screw that holds the ETG in place. Be sure not to over-tighten the screw, as you could damage your lower receiver.

You can look at the installation on someone else’s example: