How to install Magpul Enhanced Trigger Guard?

There are a few different ways to install the Magpul Enhanced Trigger Guard (ETG). Below is one method that should work for most people.

First, remove the old trigger guard from your lower receiver. Some people find it helpful to use a rubber mallet to do this, while others use a punch and a hammer.

Next, insert the new ETG into the lower receiver. You may need to wiggle it around a bit to get it in place.

Finally, use a screwdriver or other tool to tighten the screw that holds the ETG in place. Be sure not to over-tighten the screw, as you could damage your lower receiver.

You can look at the installation on someone else’s example:

The Magpul Enhanced Trigger Guard is a drop-in replacement for the standard AR-15 trigger guard that is designed to offer an improved grip for shooters with smaller hands.

The installation process is rather simple and can be done with just a few basic tools.

First, remove the old trigger guard from the receiver using a screwdriver or punch.

Next, install the new Magpul Enhanced Trigger Guard by aligning it with the receiver and pressing it into place until it snaps into position.

That’s it! You’re now ready to enjoy a better grip on your AR-15.

To install the Magpul Enhanced Trigger Guard, first, remove the old trigger guard from your firearm. Some firearms, such as the AR-15, have a pin located on the front of the trigger guard that needs to be removed before the old trigger guard can be taken off.

Once the old trigger guard is removed, insert the new Magpul Enhanced Trigger Guard into place and replace the pin. Make sure that you secure the new trigger guard in place with either a screw or some other means of fastening it down.

From there, you’re good to go! Enjoy your enhanced trigger guard and all of its benefits.

The Magpul Enhanced Trigger Guard (ETG) is a drop-in replacement for the standard AR15/M16 trigger guard. It features an enlarged opening that allows easier access to the trigger when wearing gloves and also provides enhanced protection against accidental discharges of the weapon.

To install the ETG, first, remove the old trigger guard by using a screwdriver or other sharp object to pry it out of the receiver. Then insert the new ETG into the receiver and press it into place until it snaps into position. There should be no need to use any screws or other fasteners to secure it.

First, remove the old trigger guard from the weapon. There are usually two screws located on either side of the trigger guard that holds it in place.

Once the old trigger guard is removed, insert the new Magpul Enhanced Trigger Guard into position and replace the screws. Tighten them securely but do not over-tighten, as this could damage the weapon.